Wholesale Macurco GD-6 Gas Detector Supplier Form Uzbekistan

Alarm relay is activated if gas reaches or exceeds the alarm settings Low level meter capable of displaying from 0-50% LEL EX Display, Control & Calibration Selectable (on/off) digital display, buzzer, fan delay minutes), fan minimum run time Selectable fan and alarm relay activation ETL Listed to UL 61010-1 Supervised system design: internal detector malfunction will cause the fan & alarm relay to activate One screw allows access for calibration Factory calibrated. Can also be field calibrated using 10% LEL Methane, 10% LEL Propane, or 10% LEL Hydrogen gas, regulator and calibration hood The Macurco GD-6 is an all-in-one detector, controller, and transducer that lets you select between Methane (NG), Propane (LP) or Hydrogen Gas (H2) detection. Ultra-sensitive, low-level detection at its finest, the GD-6 features advanced combustible gas monitoring in an easy-to-maintain unit that's factory calibrated for quick installation. The automatic feedback and fan control helps reduce combustible gas in a variety of environments, including parking garages, battery rooms, and maintenance facilities. The GD-6 is also available in White. A GD-6 is usually located in areas where there is potential for gas leaks; where there are gas appliances, areas through which gas pipes pass, where batteries are being stored or charged, etc. DO NOT mount the GD-6 in a corner. DO NOT mount the GD-6 where the normal ambient temperature is below 0F or exceeds 125F (-18C to 52C). If the target gas is lighter than air; natural gas (Methane) or Hydrogen (H2), mount the GD-6 high on a wall or column about one foot down from the ceiling. If the target gas is heavier than air; propane (LP), mount the GD-6 low on a wall or column one foot above the floor. Use the same spacing as for smoke detectors, 30 foot centers, 900 square feet per detector. UPC: 051131498860 Also known as: MA-GD6, GD6 Technical Specifications: Operating environ: 0°F to 125°F (-18°C to 52°C).10 to 90% RH Current loop, 4-20 mA for 0-50% LEL Alarm relay settings: OFF, 5, 10, 15, 20 (default), 25% LEL Alarm relay actuation: selectable N.O. default or N.C. Alarm relay: 0.5A 200 V, 10 VA Fan Minimum Run Time settings are OFF (default), 3, 5, 10 or 15 minutes Fan Delay Settings of 0, 1, 3 (default), 5 and 10 minutes